IAI America MSCON User Manual
Page 227
3.9
About Gateway Parameter Setting
Tool
219
2) Setting Menu
Click on the “Setting” menu on the top left corner in the main window and the setting menu list
pops up.
x
Specialty Parameter : Set the parameters related to the process of Gateway area in
MSCON.
[Refer to 3.9.3 1), 2) and 3) GW Parameter */GW Mode Select.]
x
Port Config
: Set the communication speed between the tool and PC and COM port
number.
x
Time Setting
: Set the clock retained in MSCON.
[Refer to 3.2.3 4) Clock Setting.]
x
Unit No.
: Set the unit number of MSCON and top axis number in that unit.
[Refer to 3.2.3 5) Unit Number.]
x
EtherNet/IP Setting : For EtherNet/IP type, this menu is displayed.
Set IP address etc.
[Refer to 3.9.3 6) EtherNet/IP Setting]
3) Monitor menu
Click on the [Monitor] menu on the top left corner in the main window and the monitor menu list
pops up.
(Note): “Monitor” cannot be selected before reading a parameter.
x
I/O data
: Show the details of the host PLC and MSCON data.
[Refer to 3.2.3 6) I/O data.]
x
Diagnosis Information : Show the number of ERRT and ERRC occurrence, emergency
stops and scan time.
[Refer to 3.2.3 7) Diagnosis information.]
x
Alarm List(L)
: Read and show the alarm list retained in MSCON.
[Refer to 3.2.3 8) Alarm list.]