PLANET WGSW-50040 - Manual (Page 90)

2.19 rcommand member
Command:
rcommand member
Function:
In the commander switch, this command is used to remotely manage the member switches in the
cluster.
Parameter:
commander the member id allocated by commander to each member, whose range is
1～128.
Command mode:
Admin Mode.
Usage Guide:
After executing this command, users will remotely login to a member switch and enter Admin Mode
on the latter. Use exit to quit the configuration interface of the member. Because of the use of
internal private IP, telnet authentication will be omitted on member switches. This command can
only be executed on commander switches.
Example:
In the commander switch, enter the configuration interface of the member switch with mem-id 1.
Switch#rcommand member 1