PLANET WGSW-50040 - Manual (Page 302)

Commands for Security Function Chapter 6 Commands for TACACS+
19.1.6 ipv6 mld snooping vlan immediate-leave
Command:
ipv6 mld snooping vlan immediate-leave
no ipv6 mld snooping vlan immediate-leave
Function:
Enable immediate-leave function of the MLD protocol in specified VLAN; the “no” form of this
command disables the immediate-leave function of the MLD protocol
Parameter:
is the id number of specified VLAN, with valid range of <1-4094>.
Command Mode:
Global Mode
Default:
Disabled by default
Usage Guide:
Enabling the immediate-leave function of the MLD protocol will hasten the process the port leaves
one multicast group, in which the specified group query of the group will not be sent and the port will
be directly deleted.
Example:
Enable the MLD immediate-leave function on VLAN 100.
Switch (config)#ipv6 mld snooping vlan 100 immediate-leave
19.1.7 ipv6 mld snooping vlan l2-general-querier
Command:
ipv6 mld snooping vlan < vlan-id > l2-general-querier
no ipv6 mld snooping vlan < vlan-id > l2-general-querier
Function:
Set the VLAN to Level 2 general querier.
Parameter:
vlan-id: is the id number of the VLAN, with a valid range of <1-4094>
Command Mode:
Global Mode
Default:
VLAN is not a MLD Snooping L2 general querier by default.
Usage Guide:
It is recommended to configure an L2 general querier on a segment. If before configure with this