PLANET WGSW-50040 - Manual (Page 131)

Switch(Config-Vlan100)#switchport interface ethernet 1/1;3;4-7;8
7.1.18 switchport mode
Command:
switchport mode {trunk | access}
Function:
Set the port in access mode, trunk mode or hybrid mode.
Parameter:
trunk means the port allows traffic of multiple VLAN;
access indicates the port belongs to one VLAN only; hybrid means the port allows the traffic of
multi-VLANs to pass with tag or untag mode.
Command mode:
Port Mode.
Default:
The port is in Access mode by default.
Usage Guide:
Ports in trunk mode is called Trunk ports. Trunk ports can allow traffic of multiple VLANs to pass
through. VLAN in different switches can be interconnected with the Trunk ports. Ports under access
mode are called Access ports. An access port can be assigned to one and only one VLAN at a time.
Example:
Set port 5 to trunk mode and port 8 to access mode.
Switch(config)#interface ethernet 1/5
Switch(Config-If-Ethernet1/5)#switchport mode trunk
Switch(Config-If-Ethernet1/5)#exit
Switch(config)#interface ethernet 1/8
Switch(Config-If-Ethernet1/8)#switchport mode access
Switch(Config-If-Ethernet1/8)#exit
7.1.19 switchport trunk allowed vlan
Command:
switchport trunk allowed vlan {WORD | all | add WORD | except WORD | remove WORD}
no switchport trunk allowed vlan
Function:
Set trunk port to allow VLAN traffic; the “no switchport trunk allowed vlan” command restores the