PLANET WGSW-50040 - Manual (Page 61)

1.4.13 snmp-server enable traps
Command:
snmp-server enable traps
no snmp-server enable traps
Function:
Enable the switch to send Trap message; the “no snmp-server enable traps” command disables
the switch to send Trap message.
Command mode:
Global Mode
Default:
Trap message is disabled by default.
Usage Guide:
When Trap message is enabled, if Down/Up in device ports or of system occurs, the device will
send Trap messages to NMS that receives Trap messages.
Example:
Enable to send Trap messages.
Switch(config)#snmp-server enable traps
Disable to send Trap messages.
Switch(config)#no snmp-server enable traps
1.4.14 snmp-server engineid
Command:
snmp-server engineid
no snmp-server engineid
Function:
Configure the engine ID; the “no" form of this command restores to the default engine ID.
Command Mode:
Global mode
Parameter:
<engine-string> is the engine ID shown in 1-32 digit hex characters.
Default:
Default value is the company ID plus local MAC address.
Usage Guide:
None