PLANET WGSW-50040 - Manual (Page 407)

30.3 sflow priority
Command:
sflow priority <priority-value>
no sflow priority
Function:
Configure the priority when sFlow receives packet from the hardware. The "no” form of the
command restores to the default.
Parameter:
is the priority value with a valid range of 0-3.
Command Mode:
Global Mode.
Default:
The default value is 0.
Usage Guide:
When sample packet is sent to the CPU, it is recommended not to assign high priority for the packet
so that regular receiving and sending of other protocol packet will not be interfered. The higher the
priority value is set, the higher its priority will be.
Example:
Configure the priority when sFlow receives packet from the hardware at global mode.
switch (config)#sflow priority 1
30.4 sflow header-len
Command:
sflow header-len
no sflow header-len
Function:
Configure the length of the head data packet copied in the sFlow data sampling. The “no” form of
this command restores to the default value.
Parameter:
is the value of the length with a valid range of 32-256.
Command Mode:
Port Mode.
Default:
128 by default.