PLANET WGSW-50040 - Manual (Page 325)

Commands for Security Function Chapter 6 Commands for TACACS+
21.13 ipv6 access-list
Command:
ipv6 access-list {deny | permit} {> | any-source |
{host-source }}
no ipv6 access-list <num-std>
Functions:
Creates a numbered standard IP access-list, if the access-list already exists, then a rule will add to
the current access-list; the “no access-list {|} “command deletes a
numbered standard IP access-list.
Parameters:
is the list number ,list range is between 500～599;
is the prefix of the ipv6 source address;
is the length of prefix of the ipv6 source address, range is between 1～128;
is the ipv6 source address.
Command Mode:
Global Mode.
Default:
No access-list configured.
Usage Guide:
Creates a numbered 520 standard IP access-list first time, the following configuration will add to the
current access-list.
Examples:
Creates a numbered 520 standard IP access-list, allow the source packet from 2003:1:2:3::1/64
pass through the net, and deny all the other packet from the source address 2003:1:2::1/48 pass
through.
Switch (config)#ipv6 access-list 520 permit 2003:1:2:3::1/64
Switch (config)#ipv6 access-list 520 deny 2003:1:2:::1/48
21.14 ipv6 access standard
Command:
ipv6 access-list standard
no ipv6 access-list standard
Function:
Create a name-based standard IPv6 access list; the “no ipv6 access-list
standard”command deletes the name-based standard IPv6 access list (including all