PLANET WGSW-50040 - Manual (Page 247)

Commands for Security Function Chapter 6 Commands for TACACS+
Usage Guide:
This command can be used to exclude one or several consecutive addresses in the pool from being
assigned dynamically so that those addresses can be used by the administrator for other purposes.
Example:
Reserving addresses from 10.1.128.1 to 10.1.128.10 from dynamic assignment.
Switch(config)#ip dhcp excluded-address 10.1.128.1 10.1.128.10
15.1.14 ip dhcp pool
Command:
ip dhcp pool
no ip dhcp pool
Function:
Configures a DHCP address pool and enter the pool mode; the “no ip dhcp pool
“command deletes the specified address pool.
Parameters:
is the address pool name, up to 32 characters are allowed.
Command mode:
Global Mode
Usage Guide:
This command is used to configure a DHCP address pool under Global Mode and enter the DHCP
address configuration mode.
Example:
Defining an address pool named “1”.
Switch(config)#ip dhcp pool 1
Switch(dhcp-1-config)#
15.1.15 ip dhcp conflict ping-detection enable
Command:
ip dhcp conflict ping-detection enable
no ip dhcp conflict ping-detection enable
Function:
Enable Ping-detection of conflict on DHCP server; the no operation of this command will disable the
function.
Default Settings: