PLANET WGSW-50040 - Manual (Page 155)

Function:
Set the timer for port locking; the “no switchport port-security timeout” command restores the
default setting.
Parameter:
< value> is the timeout value, the valid range is 0 to 300s.
Command mode:
Port Mode.
Default:
Port locking timer is not enabled by default.
Usage Guide:
The port locking timer function is a dynamic MAC address locking function. MAC address locking
and conversion of dynamic MAC entries to secure address entries will be performed on locking
timer timeout. The MAC address binding function must be enabled prior to running this command.
Example:
Set port1 locking timer to 30 seconds.
Switch(config)#interface Ethernet 1/1
Switch(Config-If-Ethernet1/1)# switchport port-security timeout 30
8.2.11 switchport port-security violation
Command:
switchport port-security violation {protect | shutdown}
no switchport port-security violation
Function:
Configure the port violation mode. The “no switchport port-security violation” restore the
violation mode to protect.
Command Mode:
Port mode.
Parameter:
protect refers to protect mode;
shutdown refers to shutdown mode.
Default:
The port violation mode is protect by default.
Usage Guide:
The port violation mode configuration is only available after the MAC address binding function is
enabled. when the port secure MAC address exceeds the security MAC limit, if the violation mode is
protect, the port only disable the dynamic MAC address learning function; while the port will be shut