PLANET WGSW-50040 - Manual (Page 304)

Commands for Security Function Chapter 6 Commands for TACACS+
Example:
Switch(config)#ipv6 mld snooping vlan 2 limit group 300
19.1.9 ipv6 mld snooping vlan mrouter-port interface
Command:
ipv6 mld snooping vlan <vlan-id> mrouter-port interface [<ethernet>|<port-channel>]
<ifname>
no ipv6 mld snooping vlan <vlan-id> mrouter-port interface [<ethernet>|<port-channel>]
<ifname>
Function:
Set the static mrouter port of the VLAN; the “no” form of this command cancels the configuration.
Parameter:
vlan-id: VLAN id, the valid range is<1-4094>
Ehternet: name of Ethernet port
Ifname: Name of interface
port-channel: port aggregate
Command Mode:
Global Mode
Default:
When a port is made static and dynamic mrouter port at the same time, it’s the static mrouter
properties is preferred. Deleting the static mrouter port can only be done with the “no” form of this
command.
Example:
Switch(config)#ipv6 mld snooping vlan 2 mrouter-port interface ethernet1/13
19.1.10 ipv6 mld snooping vlan mrpt
Command:
ipv6 mld snooping vlan <vlan-id> mrpt <value>
no ipv6 mld snooping vlan <vlan-id> mrpt
Function:
Configure the keep-alive time of the mrouter port.
Parameter:
vlan-id: VLAN ID, the valid range is <1-4094>
value: mrouter port keep-alive time with a valid range of <1-65535> secs.