PLANET WGSW-50040 - Manual (Page 269)

Commands for Security Function Chapter 6 Commands for TACACS+
16.20 ip user private packet version two
Command:
ip user private packet version two
no ip user private packet version two
Function:
The switch choose private packet version two to communicate with trustview.
Command Mode:
Global Mode.
Default:
The switch choose private packet version one to communicate with DCBI.
Usage Guide:
If the DCBI access control system is applied, the switch should be configured to use private protocol
of version one to communicate with the DCBI server. However, if TrustView is applied, version two
should be applied.
Example:
To configure the switch choose private packet version two to communicate with inter security
management background system.
switch(config)#ip user private packet version two
16.21 ip user helper-address
Command:
ip user helper-address <svr_addr> [port <udp_port>] source <src_addr> [secondary]
no ip user helper-address [secondary]
Function:
Set the address and port of HELPER SERVER.
Parameters:
: The IP address of HELPER SERVER 的 IP in dotted-decimal notation.
udp_port: The UDP port of HELPER SERVER, the range of which is1－65535, and its default
value is 9119.
src_addr: The local management IP address of the switch, in dotted-decimal notation.
sencondary: Whether it is a secondary SERVER address.
Command Mode:
Global mode
Default Settings: