PLANET WGSW-50040 - Manual (Page 334)

Commands for Security Function Chapter 6 Commands for TACACS+
Parameters:
num access-list serial No. this is a decimal’s No. from 3100-3199;
deny if rules are matching, deny to access;
permit if rules are matching, permit to access;
any-source-mac: any source MAC address;
any-destination-mac: any destination MAC address;
host_smac, smac: source MAC address; smac-mask: mask (reverse mask) of source MAC
address ;
host_dmac , dmas destination MAC address;
dmac-mask mask (reverse mask) of destination MAC address;
protocol No. of name or IP protocol. It can be a key word: eigrp, gre, icmp, igmp, igrp, ip, ipinip,
ospf, tcp, or udp, or an integer from 0-255 of list No. of IP address. Use key word ‘ip’ to match all
Internet protocols (including ICMP, TCP, AND UDP) list;
source-host-ip, source No. of source network or source host of packet delivery. Numbers of 32-bit
binary system with dotted decimal notation expression;
host: means the address is the IP address of source host, otherwise the IP address of network;
source-wildcard: reverse of source IP. Numbers of 32-bit binary system expressed by decimal’s
numbers with four-point separated, reverse mask;
destination-host-ip, destination No. of destination network or host to which packets are delivered.
Numbers of 32-bit binary system with dotted decimal notation expression;
host: means the address is that the destination host address, otherwise the network IP address;
destination-wildcard: mask of destination. I Numbers of 32-bit binary system expressed by
decimal’s numbers with four-point separated, reverse mask;
s-port(optional): means the need to match TCP/UDP source port;
port1(optional): value of TCP/UDP source interface No., Interface No. is an integer from 0-65535;
, the down boundary of source port; >, the up boundary of source port;
d-port(optional): means need to match TCP/UDP destination interface;
port3(optional): value of TCP/UDP destination interface No., Interface No. is an integer from
0-65535;
, the down boundary of destination port;
, the up boundary of destination port;
[ack] [fin] [psh] [rst] [urg] [syn], (optional) only for TCP protocol, multi-choices of tag positions are
available, and when TCP data reports the configuration of corresponding position, then initialization
of TCP data report is enabled to form a match when in connection;
precedence (optional) packets can be filtered by priority which is a number from 0-7;
tos (optional) packets can be filtered by service type which ia number from 0-15;
icmp-type (optional) ICMP packets can be filtered by packet type which is a number from 0-255;
icmp-code (optional) ICMP packets can be filtered by packet code which is a number from 0-255;