PLANET WGSW-50040 - Manual (Page 396)

Switch#debug mrpp
28.4 enable
Command:
enable
no enable
Function:
Enable configured MRPP ring, the “no enable” command disables this enabled MRPP ring.
Command Mode:
MRPP ring mode
Default:
Default disable MRPP ring.
Usage Guide:
Executing this command, it must enable MRPP protocol, and if other commands have configured,
the MRPP ring is enabled.
Example:
Configure MRPP ring 4000 of switch to primary node, and enable the MRPP ring.
Switch(config)#mrpp enable
Switch(config)#mrpp ring 4000
Switch(mrpp-ring-4000)#control-vlan 4000
Switch(mrpp-ring-4000)# node-mode master
Switch(mrpp-ring-4000)#fail-timer 18
Switch(mrpp-ring-4000)#hello-timer 6
Switch(mrpp-ring-4000)#enable
Switch(mrpp-ring-4000)#exit
Switch(config)#in ethernet 1/1
Switch(config-If-Ethernet1/1)#mrpp ring 4000 primary-port
Switch(config)#in ethernet 1/3
Switch(config-If-Ethernet1/3)#mrpp ring 4000 secondary-port