PLANET WGSW-50040 - Manual (Page 367)

Commands for Security Function Chapter 6 Commands for TACACS+
Enable AM function on interface 1/3 of the switch.
Switch(Config-If-Ethernet 1/3)#am port
Disable AM function on interface 1/3 of the switch.
Switch(Config-If-Ethernet 1/3)#no am port
24.3 am ip-pool
Command:
am ip-pool <ip-address>
no am ip-pool
Function:
Set the AM IP segment of the interface, allow/deny the IP messages or APR messages from a
source IP within that segment to be forwarded via the interface.
Parameters:
the starting address of an address segment in the IP address pool;
is the number of consecutive addresses following ip-address, less than or equal with 32.
Default:
IP address pool is empty.
Command Mode:
Port Mode.
Example:
Configure that interface 1/3 of the switch will forward data packets from an IP address which is one
of 10 consecutive IP addresses starting from 10.10.10.1.
Switch(Config-If-Ethernet 1/3)#am ip-pool 10.10.10.1 10
24.4 am mac-ip-pool
Command:
am mac-ip-pool <mac-address> < ip-address>
no am mac-ip-pool < ip-address>
Function:
Set the AM MAC-IP address of the interface, allow/deny the IP messages or APR messages from a
source IP within that segment to be forwarded via the interface.