PLANET WGSW-50040 - Manual (Page 420)

(3) To issue the ping6 command with parameters input interactively.
switch>ping6
Target IPv6 address:fe80::2d0:59ff:feb8:3b27
Output Interface: vlan1
Use source address option[n]:y
Source IPv6 address: fe80::203:fff:fe0b:16e3
Repeat count [5]:
Datagram size in byte [56]:
Timeout in milli-seconds [2000]:
Extended commands [n]:
Type ^c to abort.
Sending 5 56-byte ICMP Echos to fe80::2d0:59ff:feb8:3b27, using src address
fe80::203:fff:fe0b:16e3, timeout is 2 seconds.
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/4/16 ms
Display Information Explanation
ping6 The ping6 command
Target IPv6 address The target IPv6 address of the command.
Output Interface The name of he VLAN interface, which should be specified
when the target address is a local data link address.
Use source IPv6 address [n]: Whether or not use source IPv6 address. Disabled by default.
Source IPv6 address Source IPv6 address.
Repeat count[5] Number of the ping packets.
Datagram size in byte[56] Packet size of the ping command. 56 byte by default.
Timeout in milli-seconds[2000] Timeout for ping command. 2 seconds by default.
Extended commands[n] Extended configuration. Disabled by default.
! The network is reachable.
. The network is unreachable.
Success rate is 100 percent(8/8),
round-trip min/avg/max = 1/1/1ms
Statistic information, success rate is 100 percent of ping packet.