PLANET WGSW-50040 - Manual (Page 300)

Commands for Security Function Chapter 6 Commands for TACACS+
Command Mode:
Admin Configuration Mode
Usage Guide:
Use show command to check the deleted group record.
Example:
Delete the mrouter port in vlan 1.
Switch# clear ipv6 mld snooping vlan 1 mrouter-port
Relative Command:
show ipv6 mld snooping mrouter-port
19.1.3 debug mld snooping all/packet/event/timer/mfc
Command:
debug mld snooping all/packet/event/timer/mfc
no debug mld snooping all/packet/event/timer/mfc
Function:
Enable the debugging of the switch MLD Snooping; the “no” form of this command disables the
debugging.
Command Mode:
Admin Mode
Default:
The MLD Snooping Debugging of the switch is disabled by default
Usage Guide:
This command is used for enabling the switch MLD Snooping debugging, which displays the MLD
data packet message processed by the switch——packet, event messages——event, timer
messages——timer,messages of down streamed hardware entry——mfc,all debug
messages——all.
19.1.4 ipv6 mld snooping
Command:
ipv6 mld snooping
no ipv6 mld snooping
Function:
Enable the MLD Snooping function on the switch; the “no ipv6 mld snooping” command disables
MLD Snooping.