PLANET WGSW-50040 - Manual (Page 249)

Commands for Security Function Chapter 6 Commands for TACACS+
15.1.17 ip dhcp ping timeout
Command:
ip dhcp ping timeout
no ip dhcp ping timeout
Function:
Set the timeout period (in ms) of waiting for a reply message (Echo Request) after each Ping
request message (Echo Request) in Ping-detection of conflict on DHCP server, whose default value
is 500ms. The no operation of this command will restore the default value.
Parameters:
is the timeout period of waiting for a reply message after each Ping request
message in Ping-detection of conflict.
Default Settings:
The timeout period is 500ms by default.
Command Mode:
Global Configuration Mode.
Examples:
Set the timeout period (in ms) of waiting for each reply message (Echo Request) in Ping-detection
of conflict on DHCP server as 600ms.
Switch(config)#ip dhcp conflict timeout 600
Related Command:
ip dhcp conflict ping-detection enable, ip dhcp ping packets
15.1.18 lease
Command:
lease { [] [][] | infinite }
no lease
Function:
Sets the lease time for addresses in the address pool; the “no lease” command restores the default
setting.
Parameters:
is number of days from 0 to 365;
is number of hours from 0 to 23;
is number of minutes from 0 to 59;
infinite means perpetual use.
Default: