PLANET WGSW-50040 - Manual (Page 102)

Output packets statistics:
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions
Show the information of port 1/1:
Switch#show interface e1/1
Ethernet1/1 is up, line protocol is down
Ethernet1/1 is layer 2 port, alias name is (null), index is 1
Hardware is Gigabit-TX, address is 00-30-4F-02-fc-01
PVID is 1
MTU 1500 bytes, BW 10000 Kbit
Encapsulation ARPA, Loopback not set
Auto-duplex: Negotiation half-duplex, Auto-speed: Negotiation 10M bits
FlowControl is off, MDI type is auto
5 minute input rate 0 bytes/sec, 0 packets/sec
5 minute output rate 0 bytes/sec, 0 packets/sec
The last 5 second input rate 0 bytes/sec, 0 packets/sec
The last 5 second output rate 0 bytes/sec, 0 packets/sec
Input packets statistics:
0 input packets, 0 bytes, 0 no buffer
0 unicast packets, 0 multicast packets, 0 broadcast packets
0 input errors, 0 CRC, 0 frame alignment, 0 overrun, 0 ignored
0 abort, 0 length error, 0 pause frame
Output packets statistics:
0 output packets, 0 bytes, 0 underruns
0 unicast packets, 0 multicast packets, 0 broadcast packets
0 output errors, 0 collisions, 0 pause frame
Show the important information of all layer 2 ports:
Switch#show interface ethernet status
Codes: A-Down - administratively down, a - auto, f - force, G - Gigabit
Interface Link/Protocol Speed Duplex Vlan Type Alias Name
1/1 UP/UP f-100M f-full 1 G-TX
1/2 UP/UP a-100M a-full trunk G-TX
1/3 UP/DOWN auto auto 1 G-TX
1/4 A-Down/DOWN auto auto 1 G-TX
…
Show the package number statistics information of all layer 2 ports:
Switch＃Show interface ethernet counter packet