PLANET WGSW-50040 - Manual (Page 436)

Usage Guide:
This command is used to debug, it is supposed to be used with the help of the technical support.
Example：
Show the statistics of the CPU receiving arp packets.
Switch#show cpu-rx protocol arp
Type Rate-limit TotPkts CurState
arp 500 3 allowed
34.6 debug driver
Command:
debug driver {receive | send} [interface { | all}] [protocol { |
discard | all}] [detail]
no debug driver {receive | send}
Function:
Turn on the on-off of showing the information of the CPU receiving or sending packets, the “no
debug driver {receive | send}” command turn off the on-off.
Parameter:
receive | send show the information of receiving or sending packets;
interface {| all}: interface-list is the Ethernet port number,
all indicate all the Ethernet ports.
protocol { | discard | all}: protocol-type is the type of the protocol of the packet,
including snmp、telnet、http、dhcp、igmp、hsrp、arp、bgp、rip、ospf、pim、ssh、vrrp、ripng、
ospfv3、pimv6、icmpv6、bgp4plus、unknown-mcast、unknown-mcast6、ttl0-2cpu、isis、dot1x、
gvrp、stp、lacp、cluster、mld、vrrpv3、ra、uldp、lldp、eapou, all means all of the protocol types,
discard means all the discarded packets.
Detail show detail information.
Command Mode:
Admin Mode
Usage Guide:
This command is used to debug, it is supposed to be used with the help of the technical support.
Example:
Turn on the on-off for showing the receiving packets.
Switch#debug driver receive