PLANET WGSW-50040 - Manual (Page 318)

Commands for Security Function Chapter 6 Commands for TACACS+
is the access-list No. which is a decimal’s No. from 1100-1199;
deny if rules are matching, deny access;
permit if rules are matching, permit access;
any source address;
any destination address;
, source MAC address;
is the access-list No. which is a decimal’s No. from 1100-1199;
deny if rules are matching, deny access;
permit if rules are matching, permit access;
any source address;
any destination address;
, source MAC address;
mask (reverse mask) of source MAC address;
, destination MAC address;
mask (reverse mask) of destination MAC address;
untagged-eth2 format of untagged ethernet II packet;
tagged-eth2 format of tagged ethernet II packet;
untagged-802-3 format of untagged ethernet 802.3 packet;
tagged-802-3 format of tagged ethernet 802.3 packet.
Command Mode:
Global mode
Default Configuration:
No access-list configured
Usage Guide:
When the user assign specific for the first time, ACL of the serial number is created, then the
lists are added into this ACL.
Examples: P
Permit tagged-eth2 with any source MAC addresses and any destination MAC addresses and the
packets pass.
Switch(config)#access-list 1100 permit any-source-mac any-destination-mac
tagged-eth2
21.6 access-list(mac-ip extended)
Command:
access-list{deny|permit}{any-source-mac|