PLANET WGSW-50040 - Manual (Page 77)

Switch(config)#cluster commander switch
2.4 cluster ip-pool
Command:
cluster ip-pool
no cluster ip-pool
Function:
Configure private IP address pool for member switches of the cluster.
Parameters：
commander-ip:
cluster IP address pool for allocating internal IP addresses of the cluster commander-ip is the head
address of the address pool, of which the valid format is 10.x.x.x, in dotted-decimal notation; the
address pool should be big enough to hold 128 members, which requires the last byte of addresses
to be less than 126（254 – 128 = 126）. IP address pool should never be changed with commander
configured. The change can only be done after the “no cluster commander” command being
executed.
Command mode:
Global Mode
Default:
The default address pool is 10.254.254.1.
Usage Guide:
When candidate switches becomes cluster members, the commander switch allocates a private IP
address to each member for the communication within the cluster, and thus to realized its
management and maintenance of cluster members. This command can only be used on
non-commander switches. Once the cluster established, users can not modify its IP address pool.
The NO command of this command will restore the address pool back to default value, which is
10.254.254.1.
Example:
Set the private IP address pool used by cluster member devices as 10.254.254.10
Switch(config)#cluster ip-pool 10.254.254.10
2.5 cluster keepalive interval
Command:
cluster keepalive interval