PLANET WGSW-50040 - Manual (Page 225)

Function:
Display IPv6 transmission function on/off status.
\Command Mode:
Admin and Configuration Mode
Example:
Switch#show ipv6 enable
ipv6 enable has been on
Displayed information Explanation
ipv6 enable has been on IPv6 transmission switch is at on status
12.2.21 show ipv6 redirect
Command:
show ipv6 redirect
Function:
Display the state IPv6 redirect switch.
Command Mode:
Admin and Configuration Mode.
Usage Guide:
This command can be used to check whether the IPv6 redirect function in the system is enabled.
Examples:
Switch# show ipv6 redirect
ipv6 redirect is disabled
12.3 Commands for ARP Configuration
12.3.1 arp
Command:
arp > {interface [ethernet] <portName>}
no arp
Function:
Configures a static ARP entry; the “no arp ” command deletes a ARP entry of the