PLANET WGSW-50040 - Manual (Page 305)

Commands for Security Function Chapter 6 Commands for TACACS+
Command Mode:
Global Mode
Default:
255s
Usage Guide:
This configuration is applicable on dynamic mrouter port, but not on static mrouter port. To use this
command, MLD snooping must be enabled on the VLAN.
Example:
Switch(config)#ipv6 mld snooping vlan 2 mrpt 100
19.1.11 ipv6 mld snooping vlan query-interval
Command:
ipv6 mld snooping vlan <vlan-id> query-interval <value>
no ipv6 mld snooping vlan <vlan-id> query-interval
Function:
Configure the query interval.
Parameter:
vlan-id: VLAN ID, the valid range is <1-4094>
value: query interval, valid range: <1-65535>secs.
Command Mode:
Global Mode
Default:
125s
Usage Guide:
It is recommended to use default value and if layer 3 MLD is in operation, please make this
configuration in accordance with the MLD configuration as possible.
Example:
Switch(config)#ipv6 mld snooping vlan 2 query-interval 130
19.1.12 ipv6 mld snooping vlan query-mrsp
Command:
ipv6 mld snooping vlan <vlan-id> query-mrsp <value>
no ipv6 mld snooping vlan <vlan-id> query-mrsp
Function: