PLANET WGSW-50040 - Manual (Page 100)

Command Mode:
Port Mode
Default:
There is no limit on packet reception rate by default.
Usage Guide:
This command is mainly used to detect the abnormal port flow. For example, when there are a large
number of broadcast messages caused by a loop, which affect the processing of other tasks of the
switch, the port will be shut down to guarantee the normal operation of the switch.
Example:
If users set the rate-violation of port 8-10 (GB ports) of the switch as 10000pps and the port
recovery time as 1200 seconds, when the packet reception rate exceeds 10000, the port will but
shut down, and then, after 1200 seconds, the port will be UP again.
Switch(config)#interface ethernet 1/8-10
Switch(Config-Port-Range)#rate-violation 10000 recovery 1200
3.1.13 show interface
Command:
show interface [ethernet | port-channel |
loopback | vlan | tunnel | ] [detail]
show interface ethernet status
show interface ethernet counter {packet | rate}
Function:
Show information of layer 3 or layer 2 port on the switch
Parameter:
is the VLAN interface number,the value range from 1 to 4094. is the
tunnel number, the value range from 1 to 50. is the loop back number,the value range
from 1 to 1024. is the port number of the Ethernet, status show important
information of all the layer 2 ports. counter {packet | rate} show package number or rate statistics of
all layer 2 ports.
is the number of the aggregation interface,
is the name of the interface such as port-channel1.
[detail] show the detail of the port.
Command Mode:
Admin and Configuration Mode.
Default:
Information not displayed by default