PLANET WGSW-50040 - Manual (Page 234)

Commands for Security Function Chapter 6 Commands for TACACS+
13.7 anti-arpscan recovery time
Command:
anti-arpscan recovery time
no anti-arpscan recovery time
Function:
Configure automatic recovery time; “no anti-arpscan recovery time” command resets the
automatic recovery time to default value.
Parameters:
Automatic recovery time, in second ranging from 5 to 86400.
Default Settings:
300 seconds.
Command Mode:
Global configuration mode
User Guide:
Automatic recovery function should be enabled first.
Example:
Set the automatic recovery time as 3600 seconds.
Switch(config)#anti-arpscan recovery time 3600
13.8 anti-arpscan log enable
Command:
anti-arpscan log enable
no anti-arpscan log enable
Function:
Enable ARP scanning prevention log function; ”no anti-arpscan log enable” command will disable
this function.
Default Settings:
Enable ARP scanning prevention log function.
Command Mode:
Global configuration mode
User Guide:
After enabling ARP scanning prevention log function, users can check the detailed information of
ports being closed or automatically recovered by ARP scanning prevention or IP being disabled and
recovered by ARP scanning prevention. The level of the log is “Warning”.
Example: