PLANET WGSW-50040 - Manual (Page 295)

Commands for Security Function Chapter 6 Commands for TACACS+
Default:
2
Usage Guide:
It is recommended to use the default settings. Please keep this configure in accordance with IGMP
configuration as possible if layer 3 IGMP is running.
Example
Switch(config)#ip igmp snooping vlan 2 query- robustness 3
18.2.16 ip igmp snooping vlan report source-address
Command:
ip igmp snooping vlan report source-address
no ip igmp snooping vlan report source-address
Function:
Configure forward report source-address for IGMP, the “no ip igmp snooping vlan
report source-address” command restores the default setting.
Parameter:
vlan-id: VLAN ID range<1-4094>;
A.B.C.D: IP address, can be 0.0.0.0.
Command Mode:
Global Mode
Default:
Disabled.
Usage Guide:
Default configuration is recommended here. If IGMP snooping needs to be configured, the source
address for forwarded IGMP messages can be 0.0.0.0. If it is required by the upstream that IGMP
messages should use the same network address, the source address of IGMP messages should be
configured to be the same with upstream.
Example
Switch (config)#ip igmp snooping vlan 2 report source-address 10.1.1.1
18.2.17 ip igmp snooping vlan static-group
Command:
ip igmp snooping vlan static-group [source ] interface
[ethernet | port-channel]