PLANET WGSW-50040 - Manual (Page 336)

Commands for Security Function Chapter 6 Commands for TACACS+
access-list 1100(used 0 time(s))
access-list 1100 permit any-source-mac any-destination-mac tagged-eth2 14 2 0800
Displayed information Explanation
access-list 10(used 1 time(s)) Number ACL10, 0 time to be used
access-list 10 deny any source Deny any IP packets to pass
access-list 100(used 1 time(s)) Nnumber ACL10, 1 time to be used
access-list 100 deny ip any any-destination Deny IP packet of any source IP address and
destination address to pass
access-list 100 deny tcp any any-destination Deny TCP packet of any source IP address and
destination address to pass
access-list 1100 permit any-source-mac
any-destination-mac tagged-eth2 14 2 0800
Permit tagged-eth2 with any source MAC
addresses and any destination MAC addresses
and the packets whose 15th and 16th byte is
respectively 0x08 , 0x0 to pass.
21.24 show access-group
Command:
show access-group in (interface {Ethernet | Ethernet IFNAME})
Functions:
Display the ACL binding status on the port.
Parameters:
IFNAME, Port name.
Command Mode:
Admin and Configuration Mode.
Usage Guide:
When not assigning interface names, all ACL tied to port will be revealed.
Examples:
Switch#show access-group
interface name: Ethernet 1/1
IP Ingress access-list used is 100, traffic-statistics Disable.
interface name: Ethernet1/2
IP Ingress access-list used is 1, packet(s) number is 11110.