PLANET WGSW-50040 - Manual (Page 75)

Chapter 2 Commands for
Cluster
2.1 clear cluster nodes
Command:
clear cluster nodes [nodes-sn | mac-address ]
Function:
Clear the nodes in the candidate list found by the commander switch.
Parameters: c
andidate-sn-list: sn of candidate switches, ranging from 1 to 256. More than one candidate can be
specified.
mac-address: mac address of the switches (including all candidates, members and other
switches).
Default:
No parameter means to clear information of all switches.
Command Mode:
Admin Mode.
Usage Guide:
After executing this command, the information of this node will be deleted from the chain list saved
on commander switch. In 30 seconds, the commander will recreate a cluster topology and re-add
this node. But after being readded, the candidate id of the switch might change. The command can
only be executed on commander switches
Example:
Clear all candidate switch lists found by the commander switch.
Switch#clear cluster nodes
2.2 cluster auto-add
Command:
cluster auto-add
no cluster auto-add
Function: