PLANET WGSW-50040 - Manual (Page 291)

Commands for Security Function Chapter 6 Commands for TACACS+
18.2.9 ip igmp snooping vlan
l2-general-querier-version
Command:
ip igmp snooping vlan L2-general-query-version
Function:
Configure igmp snooping.
Parameter:
vlan-id is the id of the VLAN, limited to <1-4094>.
version is the version number, limited to <1-3>.
Command Mode:
Global Mode
Default:
version 3.
Usage Guide:
When the switch is connected to V1 and V2 capable environment, and for VLAN which has source
of layer 2 query configuration, the VLAN can be queried only if the version number has been
specified. This command is used to query the layer 2 version number.
Example
Switch(config)#ip igmp snooping vlan 2 L2-general-query-version 2
18.2.10 ip igmp snooping vlan limit
Command:
ip igmp snooping vlan limit {group | source }
no ip igmp snooping vlan limit
Function:
Configure the max group count of VLAN and the max source count of every group. The “no ip igmp
snooping vlan limit” command cancels this configuration.
Parameter:
is the VLAN number.
g_limit：<1-65535>, max number of groups joined.
s_limit：<1-65535>, max number of source entries in each group, consisting of include source and
exclude source.
Command Mode:
Global Mode