PLANET WGSW-50040 - Manual (Page 67)

deletes an User
Switch (config)#no snmp-server user tester
1.5 Commands for Switch Upgrade
1.5.1 copy（FTP）
Command:
copy [ascii | binary]
Function:
Download files to the FTP client.
Parameter:
is the location of the source files or directories to be copied; is the
destination address to which the files or directories to be copied; forms of and
vary depending on different locations of the files or directories. ascii indicates
the ASCII standard will be adopted; binary indicates that the binary system will be adopted in the
file transmission（default transmission method）.When URL represents an FTP address, its form
should be:
ftp://:@{|| }/,amongst
is the FTP user name, is the FTP user
password,| is the IPv4 or IPv6 address of the FTP
server/client, is the name of the host mapping with the IPv6 address,it does not support
the file download and upload with hosts mapping with IPv4 addresses, is the name of the
FTP upload/download file.
Special keywords of the filename
Keywords Source or destination addresses
running-config Running configuration files
startup-config Startup configuration files
nos.img System files
nos.rom System startup files
Command Mode:
Admin Mode.
Usage Guide:
This command supports command line hints, namely if the user can enter commands in following
forms: copy ftp:// or copy ftp:// and press Enter, following hints will be
provided by the system：
ftp server ip/ipv6 address [x.x.x.x]/[x:x::x:x] >