PLANET WGSW-50040 - Manual (Page 329)

Commands for Security Function Chapter 6 Commands for TACACS+
[no] {deny | permit} udp {{ } | any-source | {host-source }}
[s-port { > | range > }] {{ } | any-destination
| {host-destination }} [d-port { <dPort> | range <dPortMin> <dPortMax> }]
[precedence ] [tos ][time-range ]
[no] {deny | permit} {eigrp | gre | igrp | ipinip | ip | ospf | < protocol-num >} {{
} | any-source | {host-source }} {{ } | any-destination |
{host-destination }} [precedence ] [tos
][time-range]
Functions:
Create a name extended IP access rule to match specific IP protocol or all IP protocol.
Parameters:
is the source IP address, the format is dotted decimal notation;
<sMask > is the reverse mask of source IP, the format is dotted decimal notation;
is the destination IP address, the format is dotted decimal notation;
<dMask> is the reverse mask of destination IP, the format is dotted decimal notation, attentive
position o, ignored position 1;
<igmp-type>, the type of igmp, 0-15;
, the type of icmp, 0-255 ;
, protocol No. of icmp, 0-255;
, IP priority, 0-7;
, to value, 0-15;
, source port No., 0-65535;
, the down boundary of source port;
>, the up boundary of source port;
, destination port No. 0-65535;
, the down boundary of destination port;
, the up boundary of destination port;
, time range name.
Command Mode:
Name extended IP access-list configuration mode
Default:
No access-list configured.
Examples:
Create the extended access-list, deny icmp packet to pass, and permit udp packet with destination
address 192. 168. 0. 1 and destination port 32 to pass.
Switch(config)# access-list ip extended udpFlow
Switch(Config-IP-Ext-Nacl-udpFlow)#deny igmp any any-destination
Switch(Config-IP-Ext-Nacl-udpFlow)#permit udp any host-destination 192.168.0.1 d-port