PLANET WGSW-50040 - Manual (Page 404)

related access list should be prepared before this command is issued. For how to configure the
access list, please refer to ACL configuration. The mirror can only be created after the destination
interface of the corresponding session has been configured.
Example:
Configure the mirror interface 1/6 to filter with access list 120 in session 2.
Switch(config)#monitor session 2 source interface 1/6 access-list 120 rx
29.3 monitor session destination interface
Command:
monitor session destination interface
no monitor session destination interface
Function:
Specify the destination interface of the mirror. The no form command will disable this configuration.
Parameters:
<session> is the session number of the mirror, which is currently limited to 1-4.
<interface-number> is the destination interface of the mirror.
Command Mode:
Global mode
Usage Guide:
4 destination mirror interface is supported on the switch. To be mentioned. The interface which is
configured as the destination of the mirror should not be configured as the member of the interface
trunk. And the maximum throughput of the interface is recommended to be larger than the total
throughput of the interfaces to be mirrored. If the destination of a session is removed, the mirror
path configured in the session will be removed at the same time. And if the destination interface is
reconfigured, the interface, CPU and mirror path will be recovered. To be mentioned, the flow mirror
can only be recovered after the destination of the interface is re-configured.
Example:
Configure interface 1/7 as the destination of the mirror.
Switch(config)#monitor session 1 destination interface ethernet 1/7