PLANET WGSW-50040 - Manual (Page 135)

SwitchA#config
SwitchA(config)#dynamic-vlan mac-vlan prefer
7.2.2 dynamic-vlan subnet-vlan prefer
Command:
dynamic-vlan subnet-vlan prefer
Function:
Set the IP-subnet-based VLAN preferred.
Command Mode:
Global Mode.
Default:
MAC-based VLAN is preferred by default.
Usage Guide:
Configure the preference of dynamic-vlan on switch. The default priority sequence is MAC-based
VLAN、IP-subnet-based VLAN、Protocol-based VLAN, namely the preferred order when several
dynamic VLAN is available. This command is used to set to preferring the IP-subnet-based VLAN.
Example:
Set the IP-subnet-based VLAN preferred.
Switch#config
Switch(config)#dynamic-vlan subnet-vlan prefer
7.2.3 mac-vlan
Command:
mac-vlan mac vlan priority
no mac-vlan {mac |all}
Function:
Add the correspondence between MAC address and VLAN, namely specify certain MAC address to
join specified VLAN. The “no” form of this command deletes all/the correspondence.
Parameter:
mac-address is the MAC address which is shown in the form of XX-XX-XX-XX-XX-XX,vlan-id is the
ID of the VLAN with a valid range of 1~4094;priority-id is the level of priority and is used in the VLAN
tag with a valid range of 0~7;all refers to all the MAC addresses.
Command Mode:
Global Mode.