PLANET WGSW-50040 - Manual (Page 183)

10.6 mls qos cos
Command:
mls qos cos { }
no mls qos cos
Function:
Configures the default CoS value of the port; the “no mls qos cos” command restores the default
setting.
Parameters:
is the default CoS value for the port, the valid range is 0 to 7.
Default:
The default CoS value is 0.
Command mode:
Interface Configuration Mode.
Usage Guide:
Configure the default CoS value for switch port. The message ingress cos from this port are default
value whether the message have tag. If the message have no tag, the message cos value for tag is
enactmented.
Example:
Setting the default CoS value of ethernet port 1/1 to 5, i.e., packets coming in through this port will
be assigned a default CoS value of 5 if no CoS value present.
Switch(config)#interface ethernet 1/1
Switch(Config-If-Ethernet1/1)#mls qos cos 5
10.7 mls qos map
Command:
Command: mls qos map (cos-dp | dscp-dscp to |
dscp-intp to | dscp-dp to )
no mls qos map (cos-dp | dscp-dscp | dscp-intp | dscp-dp)
mls qos map intp-dscp
no mls qos map intp-dscp
Function:
Set the priority mapping of QoS, the no command restores the default mapping.
Parameters:
cos-dp defines the mapping from CoS to dp (drop precedence) value,