PLANET WGSW-50040 - Manual (Page 141)

Command:
subnet-vlan ip-address mask vlan priority
no subnet-vlan {ip-address mask |all}
Function:
Add a correspondence between the IP subnet and the VLAN, namely add specified IP subnet into
specified VLAN; the “no" form of this command deletes all/the correspondence.
Parameter:
ipv4-address is the IPv4 address shown in dotted decimal notation; the valid range of each section
is 0~255; subnet-mask is the subnet mask code shown in dotted decimal notation; the valid range of
each section is 0~255; priority-id is the priority applied in the VLAN tag with a valid range of 0~7;
vlan-id is the VLAN ID with a valid range of 1~4094;all indicates all the subnets.
Command Mode:
Global Mode.
Default:
No IP subnet joined the VLAN by default.
Usage Guide:
This command is used for adding specified IP subnet to specified VLAN. When packet without
VLAN label and from the specified IP subnet enters through the switch port, it will be matched with
specified VLAN id and enters specified VLAN. These packets will always come to the same VLAN
no matter through which port did they enter. This command will not interfere with VLAN labeled data
packets.
Example:
Add the network equipment with IP subnet of 192.168.1.0/24 to VLAN 300.
SwitchA#config
SwitchA(config)#subnet-vlan ip-address 192.168.1.1 mask 255.255.255.0 vlan 300
priority 0
7.2.13 switchport mac-vlan enable
Command:
switchport mac-vlan enable
no switchport mac-vlan enable
Function:
Enable the MAC-based VLAN function on the port; the "no” form of this command will disable the
MAC-based VLAN function on the port.
Command Mode: