PLANET WGSW-50040 - Manual (Page 331)

Commands for Security Function Chapter 6 Commands for TACACS+
<sPrefixlen> is the length of the IPv6 address prefix, the valid range is 1~128.
is the source IPv6 address.
Command Mode:
Standard IPv6 nomenclature access list mode
Default:
No access list configured by default.
Example:
Permit packets with source address of 2001:1:2:3::1/64 while denying those with source address of
2001:1:2:3::1/48.
Switch(config)#ipv6 access-list standard ipv6Flow
Switch(Config-IPv6-Std-Nacl-ipv6Flow)# permit 2001:1:2:3::1/64
Switch(Config-IPv6-Std-Nacl-ipv6Flow)# deny 2001:1:2:3::1/48
21.21 permit | deny(mac extended)
Command:
[no]{deny|permit} {any-source-mac|{host-source-mac }|{
}} {any-destination-mac|{host-destination-mac }|{
}} [cos [ ]] [vlanId <vid-value> [ <vid-mask> ]]
[ethertype <protocol> [ ]]
[no]{deny|permit} {any-source-mac|{host-source-mac }|{
}} {any-destination-mac|{host-destination-mac }|{
}} [untagged-eth2 [ethertype [protocol-mask]]]
[no]{deny|permit}{any-source-mac|{host-source-mac }|{
}} {any-destination-mac|{host-destination-mac }|{
}} [untagged-802-3]
[no]{deny|permit} {any-source-mac|{host-source-mac > }|{ >
> }} {any-destination-mac|{host-destination-mac > }|{
> }} [tagged-eth2 [cos <cos-val> [ ]] [vlanId
[ > ]] [ethertype [ ]]]
[no]{deny|permit}{any-source-mac|{host-source-mac }|{
}} {any-destination-mac|{host-destination-mac }|{
}} [tagged-802-3 [cos [ ]] [vlanId
[ ]]]
Functions:
Define an extended name MAC ACL rule, and ‘no’ command deletes this extended name IP access