PLANET WGSW-50040 - Manual (Page 101)

Usage Guide:
While for vlan interfaces, the port MAC address, IP address and the statistic state of the data packet
will be shown; for tunnel port, this command will show tunnel interface state and the statistic state of
control layer receives/sends tunnel data packet, about the statistic data of physics interface
receiving/sending data packet, please refer to show interface ethernet command; for loopback port,
this command will show the interface statistic state of IP address and receiving/sending data packet;
As for Ethernet port, this command will show port speed rate, duplex mode, flow control switch state,
broadcast storm restrain of the port and the statistic state of the data packets; for aggregated port,
port speed rate, duplex mode, flow control switch state, broadcast storm restrain of the port and the
statistic state of the data packets will be displayed. The information of all ports on the switch will be
shown if no port is specified.
Using [detail] to show the detail information for ethernet port and port-channel port, the information is
related with the type of switch, board card.
For ethernet port, using status to show important information of all the layer 2 ports by list format.
each port is a row, the showing information include port number, Link, Protocl status, Speed, Duplex,
Vlan, port type and port name; counter packets show package number statistics of all ethernet ports,
include layer 2 unicast, broadcast, multicast, error of input and output redirection package number;
counter rate show the rate statistics of all ethernet ports, input and output package number, byte
number in 5 minutes and 5 seconds.
Example:
Show the information of VLAN 1
Switch#show interface vlan 1
Vlan1 is up, line protocol is up, dev index is 2005
Device flag 0x1003(UP BROADCAST MULTICAST)
IPv4 address is:
192.168.10.1 255.255.255.0 (Primary)
Hardware is EtherSVI, address is 00-00-00-00-00-01
MTU is 1500 bytes , BW is 0 Kbit
Encapsulation ARPA, loopback not set
5 minute input rate 0 bytes/sec, 0 packets/sec
5 minute output rate 0 bytes/sec, 0 packets/sec
The last 5 second input rate 0 bytes/sec, 0 packets/sec
The last 5 second output rate 0 bytes/sec, 0 packets/sec
Input packets statistics:
Input queue 0/600, 0 drops
0 packets input, 0 bytes, 0 no buffer
0 input errors, 0 CRC, 0 frame alignment, 0 overrun
0 ignored, 0 abort, 0 length error