PLANET WGSW-50040 - Manual (Page 294)

Commands for Security Function Chapter 6 Commands for TACACS+
Switch(config)#ip igmp snooping vlan 2 query-interval 130
18.2.14 ip igmp snooping vlan query-mrsp
Command:
ip igmp snooping vlan <vlan-id> query-mrsp <value>
no ip igmp snooping vlan <vlan-id> query-mrsp
Function:
Configure the maximum query response period. The “no ip igmp snooping vlan <vlan-id>
query-mrsp” command restores to the default value.
Parameter:
vlan-id: VLAN ID, ranging between <1-4094>
value: ranging between <1-25> seconds
Command Mode:
Global Mode
Default:
10s
Usage Guide:
It is recommended to use the default settings. Please keep this configure in accordance with IGMP
configuration as possible if layer 3 IGMP is running.
Example
Switch(config)#ip igmp snooping vlan 2 query-mrsp 18
18.2.15 ip igmp snooping vlan query-robustness
Command:
ip igmp snooping vlan query-robustness <value>
no ip igmp snooping vlan query-robustness
Function:
Configure the query robustness. The “no ip igmp snooping vlan query-robustness”
command restores to the default value.
Parameter:
vlan-id: VLAN ID, ranging between <1-4094>
value: ranging between <2-10>
Command Mode:
Global Mode