PLANET WGSW-50040 - Manual (Page 204)

Chapter 12 Commands for
Layer 3 Forwarding
12.1 Commands for Layer 3 Interface
12.1.1 interface vlan
Command:
interface vlan
no interface vlan
Function:
Create a VLAN interface (a Layer 3 interface); the “no interface vlan ” command deletes
the Layer 3 interface specified.
Parameters:
<vlan-id> is the VLAN ID of the established VLAN, ranging from 1 to 4094.
Default:
No Layer 3 interface is configured upon switch shipment.
Command mode:
Global Mode
Usage Guide:
When creating a VLAN interface (Layer 3 interface), VLANs should be configured first, for details,
see the VLAN chapters. When VLAN interface (Layer 3 interface) is created with this command, the
VLAN interface (Layer 3 interface) configuration mode will be entered. After the creation of the
VLAN interface (Layer 3 interface), interface vlan command can still be used to enter Layer 3 Port
Mode.
Example:
Creating a VLAN interface (layer 3 interface).
Switch (config)#interface vlan 1
12.1.2 ip address
Command:
ip address [secondary]
no ip address ] [secondary]
Function: