PLANET WGSW-50040 - Manual (Page 188)

Switch(config)#interface ethernet 1/2
Switch(Config-If-Ethernet1/2)# mls qos queue 1 bandwidth 64 128
10.12 mls qos trust
Command:
mls qos trust {cos | dscp}
no mls qos trust {cos | dscp}
Function:
Configures port trust; the no command disables the current trust status of the port.
Parameters:
cos configures the port to trust CoS value; dscp configures the port to trust DSCP value.
Default:
Trust CoS value.
Command mode:
Port Configuration Mode.
Usage Guide:
trust cos mode: can set the intp value based cos-to-intp mapping, set the message dp value based
cos-to-dp mapping.
trust dscp mode: can set the intp field based dscp-to-intp mapping, set the dp value based
dscp-to-dp mapping, set DSCP value based dscp-to-dscp mapping.
trust cos and trust dscp can set at the same time, trust dscp priority is bigger than trust cos
priority.
Example:
Configuring ethernet port 1/1 to trust CoS value, i.e., classifying the packets according to CoS
value.
Switch(config)#interface ethernet 1/1
Switch(Config-If-Ethernet1/1)#mls qos trust cos
10.13 policy
Command:
Single Bucket Mode:
policy ({conform-action ACTION}| exceed-action