PLANET WGSW-50040 - Manual (Page 293)

Commands for Security Function Chapter 6 Commands for TACACS+
18.2.12 ip igmp snooping vlan mrpt
Command:
ip igmp snooping vlan <vlan-id> mrpt <value>
no ip igmp snooping vlan <vlan-id> mrpt
Function:
Configure this survive time of mrouter port.
Parameter:
vlan-id: VLAN ID, ranging between <1-4094>
value: mrouter port survive period, ranging between <1-65535>seconds
Command Mode:
Global Mode
Default:
255s
Usage Guide:
This command validates on dynamic mrouter ports but not on mrouter port. To use this command,
IGMP Snooping of this VLAN should be enabled previously.
Example
Switch(config)#ip igmp snooping vlan 2 mrpt 100
18.2.13 ip igmp snooping vlan query-interval
Command:
ip igmp snooping vlan <vlan-id> query-interval <value>
no ip igmp snooping vlan <vlan-id> query-interval
Function:
Configure this query interval.
Parameter:
vlan-id: VLAN ID, ranging between <1-4094>
Command Mode:
Global Mode
Default:
125s
Usage Guide:
It is recommended to use the default settings. Please keep this configure in accordance with IGMP
configuration as possible if layer 3 IGMP is running.
Example