Grass Valley UniConfi NVISION Series v.1.3 - Manual (Page 97)

UniConfig Configuration Application • User’s Guide 85
9. Managing Switch Point Settings
Updating Switch Points
Updating Switch Points
Switch points can be updated at any time. When the
Write All
button is clicked, changes are immedi-
ately written to the control card and impact the router switching matrix.
How to Update Switch Point Settings
1 Launch UniConfig. (See Launching UniConfig on page 9.)
2 Select a control card. (See Selecting a Control Card on page 10.)
3 From the menu bar, select ‘Window > Switch Point Setup’. The ‘Switch Point Setup’ window
appears displaying current output settings.
4 In the ‘Output Range’ section, enter a ‘Start’ and ‘End’ number in the fields provided and click
Read Outputs
. Outputs corresponding to the range entered display in the ‘Select Outputs to edit’
field.
5 In the ‘Select Outputs to edit’ field, select the outputs being updated.
6 Update settings for the selected outputs by checking or unchecking the check boxes as
described in the following procedures. Be sure to follow procedures for your specific router:
How to Select Switch Point Settings for the NV5100MC or NV5128 Router on page 73.
How to Select Switchpoint Settings for the NV7256 and NV7256-Plus Router on page 75.
How to Select Switch Point Settings for the NV7512 Router on page 77.
How to Select Switch Point Settings for the NV8256-Plus Router on page 79.
How to Select Switch Point Settings for the NV8288 and NV8288-Plus Routers on page 81.
How to Select Switch Point Settings for the NV8500 Family Routers on page 83.
How to Select Switch Point Settings for the EC9535 on page 123.
7 Click
Apply Changes to Selected Outputs
to apply your changes to the selected outputs. This does
not write your changes to the control cards. The changes display in the right-hand field.
8 Click
Write All
to send your changes to the control card.
9 Repeat steps 2–8 for each control card being updated.
Note Each control card must be updated separately.