Grass Valley UniConfi NVISION Series v.1.3 - Manual (Page 102)

90 Rev 1.3 • 14 Dec 09
10. Managing Inputs and Outputs
Updating ‘Connection’ Window Preferences
How to Display ‘Take’ Buttons
1 Launch UniConfig. (See Launching UniConfig on page 9.)
2 From the menu bar, select ‘Window > Connections’. The ‘Connections’ window appears with
blank fields. (See Figure 10-6 on page 93.) The ‘Connections’ window must be active to acti-
vate the necessary menu bar options.
3 Again from the menu bar, select ‘Tools > Options’. The ‘Connections Options’ dialog box
appears:
Figure 10-3. Connections Options Dialog Box with Other Tab in Front
4 Select the ‘Other’ tab to bring it to the front.
5 Check the ‘Show Take Buttons on Connection Dialog’ check box. The ‘Take’ buttons display
on the ‘Connections’ window.
6 Click
OK
to save changes and close the dialog box.
Or
Click
Cancel
to close the dialog box without saving any changes.
Updating ‘Connection’ Window Preferences
Preferences set for the ‘Connection’ window can be updated at any time. Changes to preferences
take effect immediately. Preferences include auto-refresh and incrementing or decrementing after a
‘take’ is performed.
How to Update Preferences
1 Launch UniConfig. (See Launching UniConfig on page 9.)
2 From the menu bar, select ‘Window > Connections’. The ‘Connections’ window appears with
blank fields. (See Figure 10-6 on page 93.) The ‘Connections’ window must be active to acti-
vate the necessary menu bar options.