Grass Valley UniConfi NVISION Series v.1.3 - Manual (Page 73)

UniConfig Configuration Application • User’s Guide 61
8. Managing Partitions and Signal Types
Setting Up Partitions
10 Click
Write All
to write changes to the control card.
11 Repeat steps 2 through 10 for each control card on the master router.
How to Set U p Partitions for Slave Routers
Slave routers cannot be configured separately, instead all configurations set in the master router are
automatically copied to the slave router. To change a slave router, changes must be made in the
master router, which are then copied to the slave routers.
1 Launch UniConfig. (See Launching UniConfig on page 9.)
2 Select a control card on the router acting as the slave router. (See Selecting a Control Card on
page 10.)
3 From the menu bar, select ‘Windows > Configuration’. The ‘Configuration’ window appears
displaying an ‘Expansion’ section:
Figure 8-5. Example of a Configuration Window for Routers with Frame Expansion
4 Click
Read All
. The ‘Configuration’ window populates with the current router configuration and
Ethernet settings.
NV5100
NV5128
NV5256
Data X/Y See About Data X/Y Mode
on page 50.
* If possible, connect an external AES 48kHz reference signal.
** Note: RS-232 machine control hardware is optional. For more information, contact NVISION sales.
Router Input Signal Format UniConfig Signal Type Selection Video Ref. AES Ref.