Grass Valley UniConfi NVISION Series v.1.3 - Manual (Page 131)

UniConfig Configuration Application • User’s Guide 119
12. Configuring EC9535
Entering Initial EC9535 Serial and Ethernet Settings
6 Again from the menu bar, select ‘Windows > Router Serial Configuration’. The ‘Router Serial
Configuration’ window appears: .
Figure 12-3. Router Serial Configuration Window
The ‘Router Serial Configuration’ window sets serial communication parameters for the router
control system (‘Control Settings’ sections) and for the diagnostic serial connection labeled
‘DIAG’ located on the rear of the EC9535 (‘Rear Diagnostic Port’ section).
7 In the ‘Control 1 and 2 Baud Rate Setting’ section, from the ‘Baud Rate’ drop-down list, select
‘115200’.
8 In the ‘Rear Diagnostic Port’ section, select a ‘Port type’ of ‘RS232’ and ‘Baud rate’ of
‘115200’ from the drop-down lists. This sets the communication parameters for the permanent
serial ports on the EC9535.
9 Click
Write
to write changes to the control card, overwriting any previous settings.
Warning Do not click
Read
. Clicking
Read
reads all settings on the control card, over-
writing any changes you have entered. There is no warning message.