Grass Valley UniConfi NVISION Series v.1.3 - Manual (Page 23)

UniConfig Configuration Application • User’s Guide 11
4. Configuration Basics
Viewing Configurations
Or
If you are using a serial connection, connect directly to the serial port for that control card using
either the temporary port on the control card or the permanent port on the router and then from
the menu bar, select ‘Communications > Serial’. See
Control Card Serial Port (Temporary Con-
nection) and Router Serial ‘DIAG’ Port (Permanent Connection) on page 24.
Viewing Configurations
Using the ‘Configuration’ window, configuration settings for a specific control card can be viewed
at any time. Current configurations can be viewed by clicking
Read All or by setting up the ‘Auto-
read’ function. By default, ‘Auto-read’ is enabled.
How to View Current Configuration Settings
1 Launch UniConfig. (See Launching UniConfig on page 9.)
2 Select a control card. (See Selecting a Control Card on page 10.)
3 From the menu bar, select ‘Windows > Configuration’. The ‘Configuration’ window appears:
Figure 4-1. Example of Configuration Window
Depending on the router, an additional ‘Expansion’ section displays.
4 Click
Read All
. Current configuration settings populate the ‘Configuration’ window fields.
Or
Set up the Auto-read function. By default, ‘Auto-read’ is enabled: