Grass Valley UniConfi NVISION Series v.1.3 - Manual (Page 85)

UniConfig Configuration Application • User’s Guide 73
9. Managing Switch Point Settings
Setting Up Switch Points
How to Select Switch Point Settings for the NV5100MC or NV5128
Router
1 Launch UniConfig. (See Launching UniConfig on page 9.)
2 Select a control card. (See Selecting a Control Card on page 10.)
3 From the menu bar, select ‘Window > Switch Point Setup’. The ‘Switch Point Setup’ window
appears displaying current output settings for the router being configured:
Figure 9-1. Switch Point Setup Window
4 In the ‘Output Range’ section, enter a ‘Start’ and ‘End’ output signal number in the fields pro-
vided and click
Read Outputs
. Outputs corresponding to the range entered display in the ‘Select
Outputs to edit’ pane with default settings.
The following lists each column and the information it presents:
Column Description
Output The number assigned to the signal for internal routing reference purposes. The
number usually refers to the physical port through which the signal is distributed.
Reclock/bypass Indicates if the signal bypasses re-clocking. See step 6.
HD/SD Indicates if the signal is a standard definition (SD) or high definition (HD) video
signal. See step 6.