Applied Motion RS-232 - Manual (Page 81)

81 920-0002 Rev. I
2/2013
Host Command Reference
Filter values are non-volatile for all but the BLu series of servo drives, if followed by an SA command. With a
BLu servo drive, the filter values are lost at power-down and must be set each time the drive is powered on.
NOTE: A side effect of the digital filter, which is true of any filter, is to cause a lag in the response to an input level.
When an input changes state and is solid (no noise), the lag time will be the same as the filter value. When noise
is present the lag may be longer.