Applied Motion RS-232 - Manual (Page 46)

46 920-0002 Rev. I
2/2013
Host Command Reference
*Current setting in stepper drives depends on the selected motor. Use Configurator software to select a motor
and set the maximum current setting.
Examples:
BLu, SV, SVAC3
Command Drive sends Notes
CC4.50 - Set continuous current to 4.5 amps rms
CC CC=4.5
STAC6
Command Drive sends Notes
CC4.50 - Set running current to 4.5 amps
CI2 - Set idle current to 2.0 amps
CC1.8 - Set idle current to 1.8 amps
CC CC=1.8
CI
CI=1.8 CI automatically set to 1.8 amps along with CC1.8 command
ST-Q/Si, ST-S, STM, STAC5
Command Drive sends Notes
CC3 - Set running current to 3.0 amps
CI CI=1.5 CI automatically set to 1.5 amps along with CC3 command
CI1 - Set idle current to 1.0 amps