Applied Motion RS-232 - Manual (Page 35)

35 920-0002 Rev. I
2/2013
Host Command Reference
AV - Analog Offset Value
Compatibility: All drives
Affects:
All Analog input functions
See also: AF, AP, AZ, CM & Feed commands
Sets or requests the analog offset value in volts.
Command Details:
Structure AV{Parameter #1}
Type BUFFERED
Usage READ/WRITE
Non-Volatile YES
Register Access “Z” (042)
Note: Units of AV command are different than units of “Z”
register; see Data Registers section for more details
Parameter Details:
Parameter #1 Analog offset value
- units Volts
- range BLu, SV, STAC6, ST-Q/Si, STAC5, SVAC3: -10.000 to
10.000
ST-S, STM: -5.000 to 5.000
Examples:
Command Drive sends Notes
AV0.25 - Set analog offset to 0.25 Volts
AV AV=0.25